The correct installation location of the bundle type tension clamp. The bundle type tension clamp is simple and simple, but it is often not taken seriously. In fact, just read the product manual carefully, but most of the bundle type tension clamp manufacturers now have products. There is a specified device for installing the pressure equalizing ring at the end position, but it is still found that some construction units incorrectly install or reverse the pressure equalizing ring. After the pressure equalizing ring is reverse mounted, not only the bundle type tension clamp can be evenly distributed. It will also have a serious impact on the operation of the line. In particular, the installation of the opening equalizing ring should be different according to the shape of the tower and the arrangement of the wires. The orientation of the bundle type tension clamp is also different. In addition, it is important to note that when the bundle type tension clamp is installed on the top and bottom of the equalizing ring, the direction of the bundle type tension clamp must be consistent.